Dear customer,
we are delighted to announce the release of the new SPCevo controller firmware 4.1.1.
New in this version:
• Expand Two Way Wireless portfolio with...
o • TWW Heat & Smoke added to portfolio
o New cube repeater allowing to expand signal& transmission range
o New external bell with configurable LED
o New internal bell for alarm signalization
• Minor system behaviour adjustments
o changes to strings to support VdS 2252:2015-12 (04) Section 4.3.11
o some keypad interface strings for TWW alerts were too long
• Bug fixes:
o Compatibility issue within EDP implementation using a wrong separator
o Bell retrigger adjusted according to national VdS standard
o changes to support VdS 2252:2015-12 (04) Section 4.3.11: HOLDUP TYPE ZONES: There is a limit of maximum 3 triggering of the bells. For Germany VdS classes A and C the limit does not apply, so there could be limitless retriggering. This behavior is not configurable. Note that by default holdup zones have the silent attribute enabled
o changes to support VdS 2252:2015-12 (04) Section 4.3.11: ALARM TYPE ZONES: Allow a way to configure the SPC panel so that an alarm MAY be retriggered by a different zone via the "Bell Retrigger Different Zone" and "Bell Retrigger" settings
o fix issue that allows the restore option to be displayed in the panel web interface even though a PIR mask event is still active
o EN50131: if no user
logged into the Comfort/Stylish keypad, then show any alarms as if they were
alerts
As of the 23rd of October 2025, this version is available on our homepage /download centre.
If you have any questions, please do not hesitate to contact your acre account manager.