Dear customer,
we are delighted to announce the release of the new SPCevo controller firmware 4.1.2.
New in this version:
o Expand Two Way Wireless portfolio with...
o TWW Heat & Smoke added to portfolio
o New cube repeater allowing to expand signal& transmission range
o New external bell with configurable LED
o New internal bell for alarm signalization
o Minor system behavior adjustments
o changes to strings to support VdS 2252:2015-12 (04) Section 4.3.11
o some keypad interface strings for TWW alerts were too long
Bug fixes:
o Compatibility issue within EDP implementation using a wrong separator
o Bell retrigger adjusted according to national VdS standard
o implement enhancements to optimize alarm verification performance
o changes to support VdS 2252:2015-12 (04) Section 4.3.11: HOLDUP TYPE ZONES: There is a limit of maximum 3 triggering of the bells. For Germany VdS classes A and C the limit does not apply, so there could be limitless retriggering. This behavior is not configurable. Note that by default holdup zones have the silent attribute enabled
o changes to support VdS 2252:2015-12 (04) Section 4.3.11: ALARM TYPE ZONES: Allow a way to configure the SPC panel so that an alarm MAY be retriggered by a different zone via the "Bell Retrigger Different Zone" and "Bell Retrigger" settings
o fix issue that allows the restore option to be displayed in the panel web interface even though a PIR mask event is still active
o EN50131: if no user
logged into the Comfort/Stylish keypad, then show any alarms as if they were
alerts
As of the 09th of December 2025, this version is available on request via our GTS support organization.
If you have any questions, please do not hesitate to contact your acre account manager.