Dear customer,
we are delighted to announce the release of the new SPCgen1 controller firmware 3.15.0.
New in this version:
Expand Two Way Wireless portfolio with...
o New cube repeater allowing to expand signal & transmission range
o New internal bell for alarm signalization
o Minor system behavior adjustments
o changes to strings to support VdS 2252:2015-12 (04) Section 4.3.11
o some keypad interface strings for TWW alerts were too long
Bug fixes:
o Compatibility issue within EDP implementation using a wrong separator
o Bell retrigger adjusted according to national VdS standard
o
changes to support VdS 2252:2015-12 (04) Section 4.3.11: HOLDUP TYPE
ZONES: There is a limit of maximum 3 triggering of the bells. For
Germany VdS classes A and C the limit does not apply, so there could be
limitless retriggering. This behavior is not configurable. Note that by
default holdup zones have the silent attribute enabled
o changes
to support VdS 2252:2015-12 (04) Section 4.3.11: ALARM TYPE ZONES: Allow
a way to configure the SPC panel so that an alarm MAY be retriggered by
a different zone via the "Bell Retrigger Different Zone" and "Bell
Retrigger" settings
As of the 6th of October 2025, the installer package will be available on our homepage /download centre.
If you have any questions, please do not hesitate to contact your acre account manager.